1. Products
  2. Traps
  3. Fillers and Wasteflow
Viewing: HC2650UK-FIL
1 of 2

Chrome Plated Brass Bath Filler and Overflow (Top Access Clicker)

Chrome Plated Brass Bath Filler and Overflow, 650mm long braided hose with 90° bend, Flexible Overflow Tube, Chrome Plated Brass Waste Outlet with 70mm Flange and removable top access Spring-Loaded Mushroom Plug, 1½" x 50mm Water Seal Swivel Bath Trap with Universal Outlet

  • Available in 575mm or 1m Overflow lengths

  • 1½" Outlet

  • Compact filler design (70mm x 25mm)

  • Will fit overflow hole size 46mm-65mm and suitable for curved baths

  • Industry leading flow rates (0.5 bar=33l/min, 1 bar=44l/min, 2 bar=57l/min)

  • Supplied with 650mm WRAS approved braided hose with 90° bend

  • Incorporates 1½" x 50mm water seal swivel trap with Universal outlet

  • Chrome Plated Brass Waste Outlet with 70mm Flange and Top Access Spring Loaded Mushroom Plug

  • Manufactured in Cast Brass

  • Overall Height is only 112mm

WHERE TO BUY LEAVE A REVIEW
SKU (2)
Overflow Length
  • HC2650UK-FIL
    HC2650UK-FIL
    575mm
  • HC2650UK-FIL-1M
    HC2650UK-FIL-1M
    1m
Downloads

Multifit Connections

  • Most McAlpine Trap Outlets and Fittings have Multifit Connections.
  • Multifit Connections suit all plastic waste pipes to BS EN 1451-1-2000 and BS EN 1329-1:2000, copper pipe (metric or imperial) and lead pipe.
  • The moulded Internal Sleeve of the Connection, centres and supports the pipe. The Multifit and Friction Washers ensure a secure seal is made between the pipe and the wall of the Fitting. When the compression nut is turned hand tight the best possible mechanical joint is complete.
  • If a plastic pipe is undersize, or out of shape, the end may require to be warmed to enable it to be pushed over the internal sleeve.
  • For technical reasons, it is not possible to manufacture Multifit Connections on all traps and fittings. Where Multifit is not provided the description Universal is applied. The only difference being that Universal does not have an Internal Sleeve within the Trap or Fitting.
Multifit Connector Image
hatching

Details

Multifit Connections

  • Most McAlpine Trap Outlets and Fittings have Multifit Connections.
  • Multifit Connections suit all plastic waste pipes to BS EN 1451-1-2000 and BS EN 1329-1:2000, copper pipe (metric or imperial) and lead pipe.
  • The moulded Internal Sleeve of the Connection, centres and supports the pipe. The Multifit and Friction Washers ensure a secure seal is made between the pipe and the wall of the Fitting. When the compression nut is turned hand tight the best possible mechanical joint is complete.
  • If a plastic pipe is undersize, or out of shape, the end may require to be warmed to enable it to be pushed over the internal sleeve.
  • For technical reasons, it is not possible to manufacture Multifit Connections on all traps and fittings. Where Multifit is not provided the description Universal is applied. The only difference being that Universal does not have an Internal Sleeve within the Trap or Fitting.
Multifit Connector Image
hatching
Traps Image

Download this section of the product guide